• Magrath@lemmy.ca
      link
      fedilink
      English
      arrow-up
      2
      arrow-down
      1
      ·
      6 months ago

      Supports wouldn’t have helped here. At least not automatically placed supports.

      • olicvb@lemmy.ca
        link
        fedilink
        English
        arrow-up
        8
        ·
        6 months ago

        print fell, the legs fell down and the printer kept printing onto nothing, so enjoy the spaghetti. Sometimes when moving around the nozzle can snag the parts and make them fall. Z-hop helps against that but it can’t do miracles. As VelvetStorm@lemmy.world mentioned, you need supports.

        • VelvetStorm@lemmy.world
          link
          fedilink
          English
          arrow-up
          6
          ·
          6 months ago

          Unless you are printing something that is basically just a horizontal sheet like a lithograph, you always need supports.

          • linkOPM
            link
            fedilink
            English
            arrow-up
            4
            ·
            6 months ago

            Thx, so I researched it a bit; so Z-hop means little up-and-down movement between the parts and “support” is literally an extra part independent from the main part, used for support, if I understood correct.

            I watched the video again and it seems that the problem is not due to the foot falling, but in the part where the two legs join 🤔

          • Poringo@lemmy.zip
            link
            fedilink
            English
            arrow-up
            2
            arrow-down
            1
            ·
            6 months ago

            I kindly disagree, I only add supports when there is an angle bigger than 60°. It depends on the printer, I tested mine and 60° is the limit.

            And about this video, now that I think about it, maybe the octolapse or whatever software that made the video probably touched the piece when it got into place for the screenshot, and made it fall.

            Ironically if the video was not taken, the piece may have come ok.

      • BarqsHasBite@lemmy.ca
        link
        fedilink
        English
        arrow-up
        2
        ·
        edit-2
        6 months ago

        See the very small connection at the feet? It couldn’t support the weight of the leg as the leg angled away and cantilevered. So they broke off, but the printer has no way of knowing that so it kept on printing.