[Resolved!]

I traded my cousin some really expensive RAM that I happened accross for his old desktop, that he put his graphics card into that he swapped from his newer computer. If I plug the desktop into the wall and try to turn it on nothing happens. If I open it up I can see that the where the wire from the power supply plugs into the graphics card there Is a little light on. So clearly some power is getting somewhere…

How do I go about trouble shooting this, and what tools do I need? I assume at minimum a multi meter? Not really sure what to do, it’s been decades the last time I built a computer.

Board says “Asrock H110M-HDS”

Edit: Attached a Pic and noticed the light is actually on the graphics card, not motherboard. Added addtl info.

Update: So now all of the sudden the fan spins. I am at a loss as to why it spins now, as I haven’t actually really done anything. I ordered a speaker for the mobo, so waiting for that.

Final update: It works! I apparently had either a bad monitor or bad display port cable. But using another monitor with DVI I was able to finally get it to fully boot!

I am not sure what got the fans to eventually work, maybe just a cable was jostled.

I really appreciate all the advice! I definitely know a lot more and feel better equipped to do things with it now.

  • Corkyskog@sh.itjust.worksOP
    link
    fedilink
    arrow-up
    3
    ·
    edit-2
    5 months ago

    I don’t see a spot for it on diagram or board. Everything is ziptied together, so it’s not easy to trace back right now. The system panel header is plugged in. USB 3_3_4 is plugged. CPU fan connector is plugged.

    Chassis Fan connector not plugged. USB 4_5 not plugged. Chassis intrusion and speaker header not plugged. TPM header not plugged.

    • DrDominate@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      5 months ago

      Where is says panel 1 is the correct place for the connectors to the front of the case. Two of those pins are for the power button. Make sure the connector that says pwr, both + and -, are connected to the pins on the board that are labeled pwr.

      That’s just a sanity check to make sure the power button is correctly connected. Something less common could be the power button is broken but we won’t go there just yet.