I moved my business into a new building, and there is a doorway i want to put up a door in it. However the doorway is about 1/4" narrower at the bottom, than the top. Neither of the top corners are square. I am looking for the easiest way with the least amount of work and knowledge needed to hang this door. It is only a barrier, it is not for security. It will be closed most of the time, so i am not worried if it is going to naturally swing open or closed.

Also, the cuts for the hinges on the door and the frame do not line up. I am fine with buying a new door, but I would rather not replace the frame of i can avoid it.

Any suggestions?

  • BilboBargains@lemmy.world
    22·
    4 months ago

    That door is essentially a piece of hollow plywood. Why not buy an actual piece of plywood and cut it to the size of the door frame? Modifying the frame or a hollow door is going to take far longer.

    I feel your pain though, my workshop isn’t square. I came to understand this when I replaced the roof panels which are cut perfectly square. 200mm gap at one end of the roof 😂

    • nocturne@sopuli.xyzOP
      1·
      3 months ago

      A sheet of plywood instead of a door? Being as this is the middle of my shop, I will pass on that.