This is an automated archive.

The original was posted on /r/tools by /u/NoLongerGage on 2023-08-07 22:31:09+00:00.

Mainly have 1/4, 3/8 and 1/2 drive sae and metric, and some in deep. Also have random 12 points, and some torx etc. i have used rails in the past and the clips always seem to get loose after a few uses and sockets fall off or they slide off the rail.

Bought some standing upright ones with holes drilled for standard and deep. But i can’t put them in order, its like they drilled some holes too small. Not sure what else to try without breaking the bank