It survives under your bed? That’s interesting. What material do you print most of the time? For ASA my bed is at 100 C, but I’m not sure if I’ll stick with ASA long term. Pre-Voron parts my main material was PETG.
Follow up: a clean and scuffed (with the green side of a new soong) bed, letting the printer set idle with the bed at 100c for an hour (evidently klipper will turn the bed off after 30 minutes), readjusting my x-offset (I balme the new build, but for whatever reason the nozzle wasn’t as close as it used to be), and adding a brim = great success. I’ll probably tinker some more to see if I can get rid of the brim, but I got it printed in ASA successfully.
Good to know PETG has held up. I’m thinking that my warping is due to a mix of low chamber temps (if only I could print the thing I’m going go use as my chamber heater…) and potentially x-offset being a little high. I’m going to try the usual “add a brim, make sure the bed plate is squeaky clean, etc”.
So far my ASA experience has been mixed. Natural colored polymaker ASA printed really easily. Their red was rougher, but looking back I was over extruding some. I’m onto black and it’s printing well, but corners are lifting mid print on bigger parts. Back to basics I go.
It survives under your bed? That’s interesting. What material do you print most of the time? For ASA my bed is at 100 C, but I’m not sure if I’ll stick with ASA long term. Pre-Voron parts my main material was PETG.
So far it’s held up. Ive started to print ABS. Bed gets up to 105. Probably have done about 15 prints so far. Chamber gets up to around 105.
Is ASA a problem? I was thinking of going to ASA in the future after I tweak the printer better.
Follow up: a clean and scuffed (with the green side of a new soong) bed, letting the printer set idle with the bed at 100c for an hour (evidently klipper will turn the bed off after 30 minutes), readjusting my x-offset (I balme the new build, but for whatever reason the nozzle wasn’t as close as it used to be), and adding a brim = great success. I’ll probably tinker some more to see if I can get rid of the brim, but I got it printed in ASA successfully.
Good to know PETG has held up. I’m thinking that my warping is due to a mix of low chamber temps (if only I could print the thing I’m going go use as my chamber heater…) and potentially x-offset being a little high. I’m going to try the usual “add a brim, make sure the bed plate is squeaky clean, etc”.
So far my ASA experience has been mixed. Natural colored polymaker ASA printed really easily. Their red was rougher, but looking back I was over extruding some. I’m onto black and it’s printing well, but corners are lifting mid print on bigger parts. Back to basics I go.