<- gallery of parts
I’ve been wanting to try and make a mount for space gaming to go with my office chair - a Steelcase Leap. The organic-ish arms didn’t make an easy way to create a clamp system, but in fooling around with it recently I noticed I could remove the armrest pads and they had a nice 4-bolt pattern. Since this is my office chair I need to be able to swap in or out of gaming setup easily.
I added a 30mm tall adapter that lets me slide a 6mm x 30mm (actually, 1/4x1-1/4) bar in and secure at the back, with a plate adapter to mount my old HOTAS4 to the bar, and a pin at at the rear for quick release.
The plates and adapters are eSun PLA+ which is fairly stiff but has some durability/ductility to it. The bar was supposed to be 6061-T6 aluminum but I was lazy and didn’t feel like making a mess in the shop, ripping down some surplus plate I have, and I was too cheap to go out and buy 1/4x1-1/4 steel bar stock so I decided to print the bars from PAHT-CF (high temp nylon with carbon fiber). The 385mm bars just barely fit diagonally on my CR-10s.
New Lemmy Post: $1200 chair, $60 HOTAS, $15 filament = Spaceflight Commander (https://lemmy.world/post/10397876)
Tagging: #3dprinting
(Replying in the OP of this thread (NOT THIS BOT!) will appear as a comment in the lemmy discussion.)
I am a FOSS bot. Check my README: https://github.com/db0/lemmy-tagginator/blob/main/README.md