Last week, I printed this lamp cover successfully. Print direction was “bottom to top” without any support material. Now, the last print of the same cover failed miserably. The main difference is that my Prusa MINI+ now lives within an enclosure so I assume the temperature within the enclosure might be the culprit here. Would love to hear your thoughts on it and I’m sure that you have an idea how to circumvent this situation in my next print.

I used PLA with a nozzle temperature of 200°C and a bed temperature of 60°C.

Looking forward to hear your thoughts ☺️

  • SJ_Zero@lemmy.fbxl.net
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    That’s a really good point – you can model a process as an RC where there’s a resistance and a capacitance. A major change to a process such as adding an enclosure that retains heat and reduces draft would change the process RC, so your PID settings would need to be different for optimal control.

    • NaibofTabr@infosec.pub
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Yes, if you change the conditions under which a calibration was performed, the calibration is no longer valid and needs to be repeated for the new conditions.

    • TwanHE@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Hotend and and fan pid shouldn’t be too out of whack . But needed fanspeeds and bridging would change depending on ambient temps.