Here is all the Stuff I printed with my new P1S thus far!
Since im here, I’ll need a bit of advice/guidance tho… For one, sometimes the nozzle doesn’t clean itself properly and flings its poop on the bed. From what I read I can put an A1 Nozzle Wiper somewhere to insure it cleans better?
And for the bigger, what I asume to be Issue, even when it wipes itself successfully, there always comes out a large string of Filament afterwards, which the P1S does not try to clean. Then going on to print away with this string still on. It seems very unintentional. 
While this is manageable in single colour prints, it makes using the AMS basically impossible, as this happens after every Colour change. This is what the bed looked like after my only proper Multicolour Print… 
Anyone faced the same issue who could maybe help me?
I would assume mostly from trying to speed up print time.
The benchy is a 16 minute print and it lets the quality be good enough for that. If you are slicing the files yourself it can be a lot better especially if you are setting slightly lower layer heights and slower speeds.
Not all prints have it.
But every single one I’ve seen in person does, not just the benchys. Maybe it’s something to do with default settings?
Yeah, I know people swear by print speed in some circles especially if they are printing stuff to sell and want to speed up print time as well and that’s a core selling point of Bambu Labs printers.
The default fast speed settings in the slicers to most people will be all they do. And it’s got a large user base.